Hi everyone. Welcome to my Chipboard Wall Hanging Tutorial. I hope you enjoy taking this little tutorial. If you have any questions just post them in the thread or email them to me.

Supplies I used (available at WeScrap): Chipboard, 3 Patterened Papers, cutting System, coordinating cardstock, cropadile or hole punch setter, eyelets, embellishments, rub-ons, ribbon

1. Cut the chipboard into 3 squares measuring 6X6 inches. Cut the coordinating cardstock the same.

2. Adhere the cardstock to the chipboard and ink and/or sand the edges.

3. Cut out the patterened paper and adhere them onto your squares.

4. Measure in 1 ½ inches in from the edges of two of the squares and ½ from the top or bottom edge. Mark it with a pencil and poke your holes.

5. On the other square (bottom square), only do the top edge. Do not poke holes in the bottom.

6. Cut four 4 inch strips of ribbon and pull through the eyelets. Adjust the length to your liking and adhere or knot the ribbon on the back.

7. Cut a 6 inch ribbon for the very top holes. Pull through and either adhere or knot this as well.

8. Now your Chipboard Wall Hanging is ready to embellish and add your photos to.

I hope you enjoyed trying this project.

Thanks for looking!